First, prevent material blocking
In production, according to the requirements of the crusher for the crushed materials, appropriate materials should be evenly injected into the crusher. The input materials should not be excessive, and the water-containing materials should be pretreated. At the same time, it is forbidden to enter the crushing cavity with uninterrupted hard objects, otherwise it will cause great damage to the equipment and even cause the crusher to be stopped.
Second, regular inspection of machine parts
1. Check the tightness of the V-belt.
If the belt is too loose, it will not provide sufficient power for the operation of the equipment. If it is too tight, the belt will crack especially easily, which will affect the operation of the crusher. Therefore, check the tightness of the belt before each start of the machine and during the crushing of the equipment.
2. Check the working voltage.
If the crusher is unstable or too low, it is easy to stop the equipment. Therefore, the working voltage of the crusher should be checked regularly and adjusted in time to meet the requirements of the main machine working voltage.
3. Check if the parts are loose.
If the eccentric shaft tightening sleeve is loose, the eccentric shaft can jam and cause the device to stop. In addition, if any other components become loose, it will affect the normal operation of the device. Therefore, during the production process, care should be taken to check whether the parts are loose to ensure the safe installation of the components.
Third, do a good job of maintenance
1. Maintenance of bearings.
The bearing directly affects the normal operation of the crusher, so the maintenance of the bearing is very important. In production, pay attention to check the use of the bearing, if the bearing is damaged, it should be replaced in time. In addition, it is necessary to lubricate the bearings to prevent the bearing temperature of the jaw crusher from becoming too high.
2. Maintenance of thrust plate.
Before the crusher starts, an appropriate amount of grease should be injected between the thrust plate and the adjusting seat to reduce damage to the thrust plate of the jaw crusher.
The above are some opinions provided by SBM on how to effectively reduce equipment downtime. If you have other questions, you can always communicate with our online customer service to get more specific solutions.
